Users Guide

Figure 10. PERC H840 card ports—Four enclosures with multipath configuration
To set up a multipath enclosure on the PERC H840 card:
1. To connect a single enclosure, cable the ports so that the enclosure is connected to both the ports on the controller card.
2. To connect multiple enclosures, connect two cables from the controller to the first enclosure as in case in point no 1. Next,
connect cables from the first enclosure to the second enclosure. From here, continue to connect two cables from the last
enclosure in the chain to the next enclosure you wish to include until you have up to 4 enclosures connected.
20
Features