Users Guide

Figure 21. Removing and installing the PERC FD33xD card

PERC FD33xD card 2 screw (3)

3 touch point on the cable 4 cable screw (2)

5 touch point on the PERC card (4) 6 connector on midplane interface module

9 Close the system.

10 Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.

Replacing the battery of a PERC FD33xD card

NOTE

: The procedure for replacing the battery of a PERC FD33xS card is identical to replacing the battery of a PERC FD33xD

card.

1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

NOTE

: It is recommended that you always use a static mat and static strap while working on components in the interior

of the system.

2 Open the system.

3 Locate the PERC card.

4 Remove the PERC card. For more information, see Removing the PERC FD33xD Card.

5 Disconnect the battery cables from the PERC card.

6 Slide the battery carrier in the direction of the arrow printed on the battery carrier, and then ip the battery carrier open.

7 Remove the battery from the PERC card.

Deploying the PERC card