Users Guide

3 tabs on the PCIe extender/storage controller card support

bracket

4 stando (2)

Replacing the tethered battery of a PERC 9 mini blade card

The tethered battery attached to the PERC 9 mini blade card can be replaced. This tethered battery feature is applicable only to the

PowerEdge FC630 and FC830 systems.

1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior

of the system.

2 Open the system.

3 Locate the battery carrier of the PERC card on the system board.

4 Push the tab on the battery carrier forward until the battery carrier disengages from the slot of the chassis.

Figure 17. Removing the battery carrier

tab on the battery carrier 2 battery carrier of the tethered battery

5 Disconnect the battery cable connector from the connector on the mini blade and lift the battery carrier away from the system.

6 Pull the battery out of the battery carrier.

Deploying the PERC card