Users Guide

NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function
properly if reversed.
7 Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
8 Attach the connector labeled "SAS A" to connector SAS A on the backplane, and attach the connector labeled "SAS B" to connector
SAS B on the backplane.
9 Close the system.
10 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Removing a H730P slim card
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2 Open the system.
3 Locate the H730P slim card on the system board.
4 Loosen the two retention screws on the H730P slim card cable connector.
5 Holding the pull tag, lift the H730P slim card cable connector from the system board connector.
6 Press the release latch on the side of the chassis to the unlock position and slide the H730P slim card toward the back of the system.
CAUTION: To prevent damage to the H730P slim card, you must hold the card only by its edges.
7 Lift the card up and away from the system.
8 Replace the storage controller card and connect the cable. For more information on installing the card, see Installing a H730P Slim
card.
Deploying the PERC card
47