Reference Guide

Figure 4. Removing the system cover for R730/R730xd
1
system cover 2 latch
3 latch release lock
Next steps
1 Install the system cover.
2 If applicable, remove the system from the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
3 Reconnect the peripherals and connect the system to the electrical outlet.
4 Turn on the system, including any attached peripherals.
Installing the system cover
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Turn off the system, including any attached peripherals.
3 Disconnect the system from the electrical outlet and disconnect the peripherals.
4 If applicable, remove the system from the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
Steps
1 Align the slots on the system cover with the tabs on the chassis.
2 Align the tabs at the bottom of the system cover with the slots on the chassis.
3 Push the system cover latch down.
Installing and Removing SATADOM
9