Reference Guide

Table Of Contents

Figure 2. Installing the SATADOM

SATADOM 2 SATA connector

3 power cable 4 system board power connector

Next steps

1 Install the system cover.

2 Follow the procedure listed in the After working inside your system section.

System cover

The system cover protects the components inside the system and helps in maintaining air flow inside the system. Removing the system

cover enables the intrusion switch that aids in maintaining system security.

Removing the system cover

Prerequisites

1 Follow the safety guidelines listed in the Safety instructions section.

2 Turn off the system, including any attached peripherals.

3 Disconnect the system from the electrical outlet and disconnect the peripherals.

4 If applicable, remove the system from the rack.

For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.

Steps

1 Rotate the latch release lock counter clockwise to the unlocked position.

2 Lift the latch toward the back of the system.

The system cover slides back and the tabs on the system cover disengage from the slots on the chassis.

Installing and Removing SATADOM