Reference Guide

Figure 1. Removing the SATADOM
1
SATADOM 2 SATA connector
3 power cable 4 system board power connector
Next steps
Follow the procedure listed in the After working inside your system section.
Installing the SATADOM
Prerequisites
CAUTION
: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Holding the SATADOM by its edges, position it so that the card edge connector aligns with the SATA connector on the system board.
2 Press the SATADOM until it is fully seated.
3 Reconnect all the cables.
6
Installing and Removing SATADOM