User manual

Appendix A – CLI Command Reference
ePower Power Distribution Unit User Manual, Revision 1.1 85
Example 1: Show all elements in the current default target.
ePower:/--> show
/
Targets:
session
system1
Properties:
[None]
Commands:
cd
show
help
ePower:/-->
When show is used with options other than all, such as –d properties, the
output format is the same as above, with the other elements omitted.
Example 2: Show the properties in the IPv4 target.
ePower:/--> show -d properties /system1/settings/network/ipv4
/system1/settings/network/ipv4
Properties:
address = 10.0.3.120
dhcp = N
enable = Y
gateway = 10.0.3.1
mask = 255.255.255.0