User manual

Chapter 2 – Installing the ePower PDU
22 ePower Power Distribution Unit User Manual, Revision 1.1
3. The network settings must be committed before they take effect.
Enter the following command to apply the new network settings:
commit /system1/settings/network
NOTE There can be a delay of up to 60 seconds before the new settings
take effect.
Your ePower unit should now be connected to the network. Use one of the
following methods to configure the PDU settings:
• To use the visual interface, refer to Chapter 3, “Using the ePower
Web Interface.”
• To issue individual commands or create scripts, refer to Chapter 4,
“Using the Command Line Interface,” and Appendix A, “CLI
Command Reference.”