User manual

Chapter 2 – Installing the ePower PDU
14 ePower Power Distribution Unit User Manual, Revision 1.1
Configuring the Initial ePower Communication
When the ePower unit is first powered On, the Booting screen is displayed.
This screen displays the following information:
• Serial Number
• MAC
• Model Number
After booting is complete (the screen will be dark for several seconds),
the Network Setup screen is displayed. After powering up the ePower
PDU, configure the ePower communication ports, as desired:
• RS-232 serial port, using an external PC – Refer to the Initially
Configuring the RS-232 Serial Port to Use the CLI section
• Ethernet port, using one of the following methods:
– Built-in LCD touch screen – Refer to the Configuring the
Ethernet Port Using the LCD Touch Screen section
– Command Line Interface – Refer to the Configuring the
Ethernet Port Using the CLI section