User manual

Chapter 2 – Installing the ePower PDU
ePower Power Distribution Unit User Manual, Revision 1.1 11
• Use only a grounded AC power outlet.
• Use of the ePower by children is prohibited.
• Do not place any foreign objects, other than electrical prongs,
into the outlets.
Mounting the ePower PDU
To mount the ePower unit:
1. Standing in front of the rack upon which the ePower unit will be
installed, determine where the LCD touch screen can best be viewed
and used.
NOTE The LCD touch screen automatically orients the text so that it is
readable with either of its short edges at the top.
2. The ePower unit is supplied with buttonhook mounting hardware
pre-installed in two locations on the back side of the unit. If the
mounting buttonhooks must be moved to different locations (such as
for optimum positioning of the LCD touch screen), remove them from
their current location, using a #2 Phillips screwdriver. Then, use the
Cyber Switching-supplied screws to reinstall the buttonhooks to their
new location.
WARNING The thread of the supplied pan-head screws is #8-32; the shank
of the screw must not exceed 3/16 inches.
Use of screws or other fasteners other than those supplied by Cyber Switching
voids the ePower warranty, and poses a shock hazard and shorting risk.
Please contact Cyber Switching if you need additional screws.