Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 78. Removing the mini Mezzanine card blank
Next steps
1. Install the mini Mezzanine card blank.
Installing the mini Mezzanine card blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled section.
Steps
1. Align the slot on the Mezzanine card blank with the guide on the sled or PEM.
2. Place the mini Mezzanine card blank on the mini Mezzanine card slot on the sled or PEM.
Figure 79. Installing the mini Mezzanine card blank
Next steps
1. After installing the mini Mezzanine card blank on the system board, install the PEM.
Installing and removing sled components
85