Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 76. Removing the M.2 SATA card
Next steps
1. Install the M.2 SATA card.
Installing the M.2 SATA card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled.
Steps
1. Align the M.2 SATA card at angle of 45 degrees with the SATA connector on the M.2 BOSS module.
2. Press the M.2 SATA card into the SATA connector until firmly seated in place.
3. Push down the M.2 SATA card and using Phillips #1 screwdriver, secure the M.2 SATA card to the module.
Installing and removing sled components
83