Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 75. Installing the M.2 BOSS module
Next steps
1. Install the air shroud on the system board.
2. Install the PEM.
3. Follow the procedure listed in the After working inside your sled.
Removing the M.2 SATA card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled.
3. Remove the PEM.
4. Remove the M.2 BOSS module.
Steps
1. Using the Phillips #1 screwdriver, remove the screw on the M.2 BOSS module.
2. Pull the SATA card out of the connector and lift the card away from the module.
82
Installing and removing sled components