Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Front view of the sled
The front view displays the features available on the front of the sled.
Figure 1. Front view of the sled
1.
USB 3.0 port 2. iDRAC Direct (Micro-AB USB) port
3. Drives 4. Release lever
5. Lever button 6. Information tag
7. System ID and status LED indicator 8. Power button
For more information on the drives and ports, see the Dell EMC PowerEdge MX840c Technical Specifications on the product
documentation page.
Inside the sled
NOTE:
Components that are hot swappable have orange touch points and the components that are not hot swappable
have blue touch points.
8 Dell EMC PowerEdge MX840c overview