Owners Manual

Figure 71. Installing the IDSDM module
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Install the air shroud on the system board.
3. Install the PEM.
4. Follow the procedure listed in the After working inside your sled section.
Removing a MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled section.
3. Remove the PEM.
4. Remove the IDSDM module.
Steps
1. Locate the MicroSD card slot on the IDSDM module.
2. Press the card to partially release from the slot.
3. Hold the MicroSD card, and remove it from the slot.
NOTE: Temporarily label each MicroSD card with the corresponding slot number after removal.
78 Installing and removing sled components