Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 68. Removing the Jumbo PERC card
Next steps
1. Install the Jumbo PERC card.
Installing the Jumbo PERC card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled section.
3. Remove the iDRAC card before installing the Jumbo PERC card.
Steps
1. Remove the connector cap on the I/O connector from the Jumbo PERC card.
2. Lift the blue pull tags to raise the lever up on the Jumbo PERC card.
3. Align the connector, guides, and guide slots on the Jumbo PERC card and the sled.
4. Lower and press the Jumbo PERC card to firmly seat on the system board connector and close the lever on the Jumbo
PERC card.
Installing and removing sled components
75