Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Installing the iDRAC card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled section.
CAUTION: If either the system board or iDRAC card fails, it is required to replace the system board and iDRAC
card simultaneously.
Steps
1. Align the iDRAC card with the connector and guide pin on the system board.
2. Lower the iDRAC card on the system board connector and press the blue push points until the iDRAC card is firmly seated
on the system board connector.
Figure 64. Installing the iDRAC card
NOTE: The iDRAC card is not swappable with other MX series sleds in the MX7000 enclosure.
NOTE: The procedure to install a vFlash card is similar to installing a MicroSD card.
Figure 65. Installing a vFlash card
72
Installing and removing sled components