Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
4. Remove the air shroud from the system board.
CAUTION: If either the system board or iDRAC card fails, it is required to replace the system board and iDRAC
card simultaneously.
Steps
Hold the blue pull tag, and lift the iDRAC card away from the sled.
Figure 62. Removing the iDRAC card
NOTE: The iDRAC card is not swappable with other MX series sleds in the MX7000 enclosure.
NOTE: The procedure to remove vFlash card is similar to removing a MicroSD card.
Figure 63. Removing a vFlash card
Next steps
1. Install the iDRAC card.
Installing and removing sled components
71