Owners Manual

4. Press the memory module with your thumbs until the socket levers firmly click into place.
Figure 54. Installing a memory module on the system board or PEM
Next steps
1. After installing the memory module on the system board,
a. Install the air shroud into the system board.
b. Install the PEM.
2. After installing the memory module on the PEM, install the air shroud on the PEM.
3. Follow the procedure listed in the After working inside your sled section.
4. To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System
BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of
the installed memory.
5. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module
is firmly seated in the memory module socket.
6. Run the system memory test in system diagnostics.
Processors and heat sinks
The processor controls memory, peripheral interfaces, and other components of the system. The system can have more than
one processor configurations.
The heat sink absorbs the heat generated by the processor, and helps the processor to maintain its optimal temperature level.
Processor wattage and heat sink dimensions
Table 12. Processor wattage and heat sink dimensions
Processor
configuration
Processor type Heat sink width Number of DIMMs,
Maximum
Number of DIMMs,
RAS (Reliability,
Availability, and
Serviceability)
All up to 205 W 90 mm 12 12
64 Installing and removing sled components