Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
6. Disconnect the cables that are connected to the drive backplane.
Steps
1. Using Phillips #2 screwdriver, loosen the two captive screws on the drive backplane.
2. Holding the edges, lift the backplane away from the sled.
Figure 33. Removing the drive backplane
Next steps
1. Install the drive backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your sled section.
Steps
1. Align the hooks and captive screws on the drive backplane with the slots and screw holes on the sled.
2. Lower the drive backplane until it seat into place.
3. Using a Phillips #2 screwdriver, tighten the two captive screws to secure the drive backplane to the sled.
Installing and removing sled components
37