Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Steps
1. Press the release button on the front of the drive carrier to open the release handle.
2. Insert the drive carrier into the drive slot and slide until the drive carrier connects with the backplane.
3. Close the release handle of the drive carrier to lock the drive in place.
Figure 28. Installing a drive carrier
Removing a drive from the drive carrier
Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2. Lift the drive out of the drive carrier.
Installing and removing sled components
33