Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 15. Removing the I/O connector cover from the sled
NOTE: The color of the I/O connector cover may differ.
2. Press the blue lever button on the sled to release the lever.
3. Holding the sled with two hands, align the sled with the bay in the enclosure and slide the sled into the enclosure until firmly
seated.
4. Rotate the lever up until it clicks into place and secures the sled in the enclosure.
Figure 16. Installing the sled into the enclosure
Installing and removing sled components
21