Owners Manual

Initial system setup and configuration
Topics:
• Setting up your sled
•
iDRAC configuration
• Options to install the operating system
Setting up your sled
Complete the following steps to set up your sled:
Steps
1. Unpack the sled.
2. Remove the I/O connector cover from the sled connectors.
CAUTION: While installing the sled, ensure that it is properly aligned with the slot on the enclosure to
prevent damage to the sled connectors.
3. Install the sled in the enclosure.
4. Power on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
5. Press the power button on the sled.
Alternatively, you can also power on the sled by using:
● The sled iDRAC. For more information, see the Log in to iDRAC section.
● Open Manage Enterprise modular (OME-modular), after the sled iDRAC is configured on the OME. For more information,
see the OME-modular User’s Guide at www.dell.com/openmanagemanuals.
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve
the overall availability of Dell systems. iDRAC alerts administrators about system issues and enables them to perform remote
system management. This reduces the need for physical access to the system.
Options to set up iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from
iDRAC.
You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
utility
See Dell Integrated Dell Remote Access Controller User's Guide at www.dell.com/poweredgemanuals
Dell Deployment
Toolkit
See Dell Deployment Toolkit User’s Guide at www.dell.com/openmanagemanuals > OpenManage
Deployment Toolkit
3
14 Initial system setup and configuration