Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX840c Installation and Service Manual
- About this document
- Dell EMC PowerEdge MX840c overview
- Initial system setup and configuration
- Installing and removing sled components
- Safety instructions
- Before working inside your sled
- After working inside your sled
- Recommended tools
- PowerEdge MX840c sled
- Sled cover
- Air shroud
- Processor expansion module
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Battery backup unit
- Control panel
- System memory
- Processors and heat sinks
- iDRAC card
- PERC cards
- Optional Internal dual SD module
- M.2 BOSS module
- Mezzanine card
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Locating the Service Tag of the sled
The PowerEdge MX840c sled is identified by a unique Express Service Code and Service Tag number. The Express Service Code
and Service Tag are found on the front of the enclosure by pulling out the Information Tag. Dell uses this information to route
support calls to the appropriate personnel.
Figure 4. Information Tag of the sled
1. Information Tag
2. Service Tag
System information label
Figure 5. PowerEdge MX840c service information
10
Dell EMC PowerEdge MX840c overview