Owners Manual

Figure 69. Installing the Jumbo PERC card

Next steps

1. Connect the cable to the Jumbo PERC card.

2. Install the air shroud on the system board.

3. Install the PEM.

4. Follow the procedure listed in the After working inside the sled section.

Optional Internal dual SD module

The optional internal dual SD module (IDSDM) has two MicroSD card sockets. The IDSDM is available with a single MicroSD card

in slot 1 or in redundant mode with two MicroSD cards installed.

NOTE: The write-protect switch is on the IDSDM module.

Removing the optional IDSDM module

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled section.

3. Remove the PEM.

4. Remove the air shroud from the system board.

5. If you are replacing the IDSDM module, remove the MicroSD cards.

NOTE: Temporarily label each MicroSD card with the corresponding slot number after removal.

Steps

1. Locate the IDSDM module connector on the system board.

NOTE: To locate IDSDM module connector, see the System board jumpers and connectors section.

2. Hold the blue pull tag, lift the IDSDM module out of the sled.

Installing and removing sled components