Owners Manual

Figure 68. Removing the Jumbo PERC card

Next steps

1. Install the Jumbo PERC card.

Installing the Jumbo PERC card

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled section.

3. Remove the iDRAC card before installing the Jumbo PERC card.

Steps

1. Remove the connector cap on the I/O connector from the Jumbo PERC card.

2. Lift the blue pull tags to raise the lever up on the Jumbo PERC card.

3. Align the connector, guides, and guide slots on the Jumbo PERC card and the sled.

4. Lower and press the Jumbo PERC card to firmly seat on the system board connector and close the lever on the Jumbo

PERC card.

Installing and removing sled components