Owners Manual

Figure 55. Removing the processor and heat sink module

Next steps

1. Install the processor and heat sink module.

Removing the processor from the processor and heat sink module

Prerequisites

NOTE:

Only remove the processor from the processor and heat sink module (PHM) if you are replacing the processor or

heat sink. This procedure is not required when replacing a system board.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled section.

3. Remove the processor and heat sink module.

Steps

1. Place the heat sink with the processor side facing up.

2. Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break

the thermal paste seal.

3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.

Installing and removing sled components