Owners Manual

Figure 46. Installing the BBU module

3. Connect the cables on the BBU to the connectors on the system board.

Next steps

1. Install the PEM.

2. Follow the procedure listed in the After working inside your sled section.

Removing the BBU from the BBU cage

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in the Before working inside your sled section.

3. Remove the battery backup unit module.

Steps

1. Using a Phillips #1 screwdriver, loosen the captive screw securing the BBU to the BBU cage.

2. Lift and slide the BBU out of the BBU cage.

Installing and removing sled components