Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Upgrade Kits
NOTE: Kit includes SATA, SAS, PCIE and Jumbo SAS cables. Not all cables are required for each configuration. Cables are
required based on the configuration.
Table 30. Upgrade kits
Kits Related links to service instructions
PERC H755 MX See Installing the H755 MX card
PERC H745P MX (Jumbo PERC) See Installing the H745P MX card
HBA350i MX See Installing the HBA350i MX card
1. Identify the backplane (see column Backplane configuration in the table).
Figure 91. x6 universal backplane
Figure 92. x4 universal backplane
Figure 93. x6 SAS/SATA backplane
2. Identify the current system configuration (see column Upgrade from in the table) and the upgrade to configuration (see
column Upgrade to in the table).
3. Disconnect the card or cables (see column Disconnect and remove card or cables from the connector in the table) and
replace with the card or cables (see column Replace with the card or cables in the table).
4. For the final cabling configuration (see column Refer to cabling configurations in the table).
6
98 Upgrade Kits