Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
NOTE: The mini Mezzanine card is supported only on systems with two processors.
Steps
1. Remove the connector cap on the I/O connector of the mini Mezzanine card.
2. Pull the blue pull tag to raise the lever on the mini Mezzanine card.
3. Align the mini Mezzanine card connector with the connector on the system board.
4. Insert the mini Mezzanine card firmly until it is fully seated.
Figure 81. Installing the mini Mezzanine card (HBA330 MMZ)
5. Close the lever on the mini Mezzanine card.
Next steps
1. Follow the procedure listed in After working inside your system.
Removing the mini Mezzanine card blank
Prerequisites
CAUTION:
To ensure proper system cooling, the mini Mezzanine blank must be installed in the mini Mezzanine
socket.
NOTE: The removal of the blank is recommended only if you intend to install a mini Mezzanine card in the socket.
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
Lift the mini Mezzanine card blank from the slot to remove it from the system.
Installing and removing system components
87