Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 75. Installing the M.2 SSD module
Next steps
1. Install the M.2 BOSS module.
2. Follow the procedure listed in the After working inside your system.
Mezzanine cards
The PowerEdge MX750c system supports:
● One x16 PCIe Gen4 slot for PERC – connected to processor 1
● One x16 PCIe Gen4 slot for Mezz A – connected to processor 1
● One x16 PCIe Gen4 slot for Mezz B – connected to processor 2
● One x16 PCIe Gen4 slot for mini-Mezz card – connected to processor 2
Mezzanine card installation guidelines
The following table describes the supported mezzanine cards:
Table 29. Mezzanine card riser configurations
Mezzanine card category Description Slot priority Maximum cards
(Fl)
Ethernet Mezz Broadcom PCIe Gen4 Quad-Port
25Gb NIC
Mezzanine slot A or B (populate
A first)
2
QLogic PCIe Gen3 QL41262 DP
25Gb CNA
Mezzanine slot A or B (populate
A first)
2
Intel PCIe Gen3 DP 25Gb CNA Mezzanine slot A or B (populate
A first)
2
Fibre channel HBAs Emulex (FC32 DP) Mezzanine slot C (mini-Mezz
slot)
1
82 Installing and removing system components