Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Table 33. PERC H745P MX upgrade kit (continued)
Backplane
configuration
Upgrade from: Upgrade to: Disconnect and
remove card or
cables from the
connector (cable
marking):
Replace with the
card or cables
(cable marking):
Refer to cabling
configurations
with H745P MX
(Jumbo PERC) +
on board PCIe
X6 SAS/SATA
backplane
Onboard SATA/
SWRAID
H745P MX (Jumbo
PERC)
SATA cable (MB
SL6 – BP SA1)
● H745P MX card
● Jumbo SAS
cable
(CTRL_SA1 –
BP SA1)
Cable routing
> SAS cabling
diagram of
configuration 7 -
6 x 2.5-inch SAS/
SATA backplane
with H745P MX
(Jumbo PERC)
H755 MX (SAS
controller)
H745P MX (Jumbo
PERC)
● H755 MX SAS
● SAS cable
(CTRL_SA1 –
BP SA1)
● H745P MX card
● Jumbo SAS
cable
(CTRL_SA1 –
BP SA1)
Cable routing
> SAS cabling
diagram of
configuration 7 -
6 x 2.5-inch SAS/
SATA backplane
with H745P MX
(Jumbo PERC)
HBA350i Upgrade kit
The below table provides the upgrade kit information about HBA350i available After Point of Sale (APOS):
Table 34. HBA350i upgrade kit
Backplane
configuration
Upgrade from: Upgrade to: Disconnect and
remove card or
cables from the
connector (cable
marking):
Replace with the
card or cables
(cable marking):
Refer to cabling
configurations
X4 Universal
backplane
Onboard SATA/
SWRAID/NVME
HBA350i
(SAS Controller/
Non–RAID)
SATA cable (MB
SL6 – BP SA1)
● HBA350i card
● SAS cable
(CTRL_SA1–BP
SA1)
Cable routing
> SAS/PCIe
cabling diagram
of configuration 9
- 4 x 2.5-inch
Universal backplane
with H755 MX + on
board PCIe
H745P MX (Jumbo
PERC)
HBA350i
(SAS Controller/
Non–RAID)
● H745P MX card
● Jumbo SAS
cable
(CTRL_SA1–BP
SA1)
● HBA350i card
● SAS cable
(CTRL_SA1–BP
SA1)
Cable routing
> SAS/PCIe
cabling diagram
of configuration 9
- 4 x 2.5-inch
Universal backplane
with H755 MX + on
board PCIe
X6 SAS/SATA
backplane
Onboard SATA/
SWRAID
HBA350i
(SAS Controller/
Non–RAID)
SATA cable (MB
SL6 – BP SA1)
● HBA350i card
● SAS cable
(CTRL_SA1–BP
SA1)
Cable routing
> SAS/PCIe
cabling diagram
of configuration 9
- 4 x 2.5-inch
Universal backplane
Upgrade Kits 103