Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 73. Installing the M.2 BOSS card
Next steps
1. Follow the procedure listed in the After working inside your system.
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the M.2 SSD module to the M.2 BOSS card.
2. Pull the M.2 SSD module to remove it from the M.2 BOSS card.
Installing and removing system components
79