Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 61. Set the Anti-Tilt wires to the locked position and tightening the screws
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
PERC card
Your system includes dedicated slots on the system board for PERC cards.
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety Instructions.
2. Follow the procedure listed in Before working inside your system.
3. Disconnect the cable connected to the PERC card.
Steps
1. Pull the blue pull tag to lift the lever up on the PERC card.
2. Holding the blue pull tag, lift the PERC card out of the system.
68
Installing and removing system components