Owners Manual
Table Of Contents
- Dell EMC PowerEdge MX750c Installation and Service Manual
- Contents
- About this document
- Dell EMC PowerEdge MX750c system overview
- Initial system setup and configuration
- Minimum to POST and system management configuration validation
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- PowerEdge MX750c sled
- Sled cover
- Air shroud
- Processor and memory module blank
- Drives
- Drive backplane
- Cable routing
- Drive cage
- Control panel
- System memory
- Processor and heat sink module
- PERC card
- Optional IDSDM module
- M.2 BOSS card
- Mezzanine cards
- Optional internal USB memory key
- System battery
- System board
- Trusted Platform Module
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Figure 26. Installing a drive into drive carrier
Next steps
1. Install the drive carrier.
Drive backplane
Drive backplane details
Depending on the configuration, your system supports:
● 2.5-inch (x6) Universal backplane
● 2.5-inch (x6) SAS/SATA backplane
● 2.5-inch (x4) Universal backplane
Figure 27. 6 x 2.5-inch universal backplane
1. BP_DST_PA2 (PCIe cable connector)
2. BP_DST_PB1 (PCIe cable connector)
3. BP_DST_SA1 (SAS/SATA cable connector)
4. BP_PWR_1 (Power cable connector)
5. BP_DST_PA1 (PCIe cable connector )
36
Installing and removing system components