Reference Guide

67 Dell EMC PowerEdge MX SmartFabric Deployment Guide

9.5.2 Validation using the MX9116n CLI

The CLI commands shown in this section are available to help validate the configuration. The commands and

output shown below are from the MX9116n in the first chassis. The CLI output from the MX9116n in the

second chassis, not shown, is similar.

Note: The MX9116n CLI is accessible using SSH. The default username and password are both admin.

9.5.2.1 show switch-operating-mode

Use the show switch-operating-mode command to display the current operating mode.

MX9116n-1# show switch-operating-mode

Switch-Operating-Mode : Smart Fabric Mode

9.5.2.2 show discovered-expanders

The show discovered-expanders command is only available on the MX9116n FSE and displays the

MX7116n FEMs service tag attached to the MX9116n FSEs and the associated port-group and virtual slot.

MX9116n-1# show discovered-expanders

Service Model Type Chassis Chassis-slot Port-group Virtual

tag service-tag Slot-Id

--------------------------------------------------------------------------

CBJWLN2 MX7116n FEM 1 CF54XM2 A1 1/1/1 71

9.5.2.3 show unit-provision

The show unit-provision command is only available on the MX9116n FSE. It displays the unit ID, name,

and the state of each MX7116n FEM attached to the MX9116n FSE.

MX9116n-1# show unit-provision

---------+---------+---------------------------------+-------|

1 | 71 | CBJWLN2 | CBJWLN2 | up |

(output truncated)