CLI Reference Guide

664 Multicast Commands
www.dell.com | support.dell.com
• group/destination — Multicast IP address of the group being displayed/IP address of the
receiver device.
Default Configuration
The default value for group is 224.2.0.1. The default value for destination is the IP address of
the device which issues the command.
Command Mode
Privileged EXEC mode
User Guidelines
Enter the group and receiver IP addresses in any order.
Example
The following example finds the IP Multicast path from a source to a receiver (unicast router
ID of the host running mtrace).
console(config)#mtrace 10.1.1.1
no ip mcast mroute
Use the no ip mcast mroute command in Global Configuration mode to clear entries in the
mroute table.
Syntax
no ip mcast mroute {group groupipaddr | source sourceipaddr [ groupipaddr ] | all}
• groupipaddr — Clears the route entries in the mroute table containing the specified
multicast group IP addresses.
•
sourceipaddr — Clears the route entries in the mroute table containing the specified
source IP addresses.
• all— Clears all entries.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.