CLI Reference Guide

16 Command Groups
www.dell.com | support.dell.com
ACL Commands
Line Commands
Command Description Mode*
access-list Creates an Access Control List (ACL) that is identified by
the parameter accesslistnumber.
IC
deny|permit The deny command denies traffic if the conditions defined
in the deny statement are matched. The permit command
allows traffic if the conditions defined in the permit
statement are matched.
ML
ip access-group Attaches a specified access-control list to an interface. GC or
IC
ip access-group <name> out Applies an IP based egress ACL on an Ethernet interface or
a group of interfaces.
IC
mac access-group Attaches a specific MAC Access Control List (ACL) to an
interface in a given direction.
GC or
IC
mac access-list extended Creates the MAC Access Control List (ACL) identified by
the name parameter.
GC
mac access-list extended rename Renames the existing MAC Access Control List (ACL)
name.
GC
show ip access-lists Displays an Access Control List (ACL) and all of the rules
that are defined for the ACL.
PE
show mac access-list Displays a MAC access list and all of the rules that are
defined for the ACL.
PE
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.
Command Description Mode*
exec-timeout Configures the interval that the system waits for user input. LC
history Enables the command history function. UE
history size Changes the command history buffer size for a particular
line.
UE
line Identifies a specific line for configuration and enters the
line configuration command mode.
GC
show line Displays line parameters. UE
speed Sets the line baud rate. LC
*NOTE: For the meaning of each Mode abbreviation, see Mode Types on page 4.