CLI Reference Guide

270 System Management Commands
www.dell.com | support.dell.com
The following table describes the fields in the example.
This example displays information about all units in the stack.
console>show switch
Switch Management Preconfig Plugged-in Switch Code
Status Model ID Model ID Status Version
-------------------------------------------------------------
1 Mgmt Switch PCT6224 PCT6224 1.12.21.1
Unit Description
Switch This field displays the unit identifier assigned to the
switch.
Management Status This field indicates whether the switch is the
Management Switch, a stack member, or the status is
unassigned.
Admin Management Preference This field indicates the administrative management
preference value assigned to the switch. This preference
value indicates how likely the switch is to be chosen as
the Management Switch.
Switch Type This field displays the 32-bit numeric switch type.
Model Identifier This field displays the model identifier for this switch.
Model Identifier is a 32-character field assigned by the
switch manufacturer to identify the switch.
Switch Status This field displays the switch status. Possible values are
OK, Unsupported, Code Mismatch, Config Mismatch, or
Not Present.
Switch Description This field displays the switch description.
Expected Code Version This field indicates the expected code version.
Detected Code Version This field displays the version of code running on this
switch. If the switch is not present and the data is from
preconfiguration, the code version is "None."
Detected Code in Flash This field displays the version of code that is currently
stored in FLASH memory on the switch. This code will
execute after the switch is reset. If the switch is not
present and the data is from pre-configuration, then the
code version is "None."
Boot Code Version This field displays the version of the boot strapping code.
Up Time This field displays the system up time.