Users Guide

Defaults Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434

Command Modes

• EXEC

• EXEC Privilege

Supported Modes All Modes

Command History

Version Description

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

Usage Information When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are

prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3), minimum

TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default setting for

those parameters, press the ENTER key.

Example (IPv4)

Dell#traceroute www.force10networks.com

Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]

Type Ctrl-C to abort.

---------------------------------------------------------------------------------

---------

Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte

packets

---------------------------------------------------------------------------------

---------

TTL Hostname Probe1 Probe2 Probe3

1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms

2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms 001.000 ms

001.000 ms

3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000

4 www.force10networks.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms

Dell#

Related Commands

ping — Tests the connectivity to a device.

undebug all

Disable all debug operations on the system.

Syntax