Users Guide
[5/4 9:19:35]: CMD-(TEL0):[configure]by admin from vty0 (10.11.68.14)
- Repeated 1 time.
[5/4 9:19:50]: CMD-(TEL0):[interface tengigabitethernet 0/16]by admin from
vty0
(10.11.68.14)
[5/4 9:20:11]: CMD-(TEL0):[exit]by admin from vty0 (10.11.68.14)
Dell#
Related Commands clear command history — clears the command history log.
show conguration lock
Display the conguration lock status.
Syntax
show configuration lock
Defaults None
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The type may be auto, manual, or rollback. When set to auto, Dell Networking OS automatically denies
access to CONFIGURATION mode to all other users every time the user on the listed VTY line enters
CONFIGURATION mode. When set to manual, the user on the listed VTY line must explicitly set the lock
each time before entering CONFIGURATION mode. Rollback indicates that Dell Networking OS is in a
rollback process. The line number shown in the output can be used to send the messages to that session or
release a lock on a VTY line.
Example
Dell#show configuration lock
Configure exclusively locked by the following line:
Line : vty 0
Line number : 2
User : admin
Type : AUTO
State : LOCKED
Ip address : 10.11.9.97
Dell#
show cpu-trac-stats
Display the CPU trac statistics.
Syntax
show cpu-traffic-stats [port number | all]
Parameters
port number (OPTIONAL) Enter the port number to display trac statistics on that port only.
The range is from 1 to 1568.
Control and Monitoring
57