Users Guide
Related Commands telnet — telnets to another device.
line
Enable and congure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the
access conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to congure the console port.
The console option is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to congure a virtual
terminal line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to
congure.
You can congure multiple lines at one time.
Defaults Not congured
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information You cannot delete a terminal connection.
Related Commands show memory— View current memory usage on the M I/O Aggregator.
ping
Test connectivity between the system and another device by sending echo requests and waiting for replies.
Syntax
ping [host | ip-address] [count {number | continuous}] [datagram-size]
[timeout] [source (ip src-ipv4-address) | interface] [tos] [df-bit (y|n)]
[validate-reply(y|n)] [pattern pattern] [sweep-min-size] [sweep-max-size]
[sweep-interval] [ointerface (ip src-ipv4-address) | interface]
Parameters
host (OPTIONAL) Enter the host name of the devices to which you are testing
connectivity.
52
Control and Monitoring