Users Guide

debug cpu-trac-stats
Enable the collection of computer processor unit (CPU) trac statistics.
Syntax
debug cpu-traffic-stats
Defaults Disabled
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information This command enables (and disables) the collection of CPU trac statistics from the time this command is
executed (not from system boot). However, excessive trac a CPU receives automatically triggers (turn on)
the collection of CPU trac statics.
To view the trac statistics, use the show cpu-traffic-stats command.
If the CPU receives excessive trac, trac is rate controlled.
NOTE: You must enable this command before the show cpu-traffic-stats command
displays trac statistics. Dell Networking recommends disabling debugging (no debug cpu-
traffic-stats) after troubleshooting is complete.
Related Commands show cpu-trac-stats— displays the cpu trac statistics.
debug ifm trace-ags
Turn on the IFM internal trace-ags.
Syntax
debug ifm trace-flags trace-flags
To disable this command, use the no debug ifm trace-flags command.
Parameters
trace-ags Enter a hexadecimal number representing the trace-ag.
Defaults None
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
NOTE: Use this command only when you are working directly with a technical support
representative to troubleshoot a problem. Do not use this command unless a technical support
representative instructs you to do so.
46
Control and Monitoring