Users Guide

Supported Modes Standalone-Mux (SMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This command is not available in PMUX mode.
show io-aggregator broadcast storm-control status
Shows if storm control is enabled or disabled. If enabled, displays information on the rate limit value.
Syntax
show io-aggregator broadcast storm-control status
Command Modes
• EXEC Privilege
Supported Modes Standalone-Mux (SMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show io-aggregator broadcast storm-control status
Storm-Control Enabled
Broadcast Traffic limited to 1000 Mbps
Dell#
show storm-control unknown-unicast
Display the storm control unknown-unicast conguration.
Syntax
show storm-control unknown-unicast [interface]
Parameters
interface (OPTIONAL) Enter one of the following interfaces to display the interface specic
storm control conguration:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then y the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/ port information.
Defaults none
Command Modes
• EXEC
Storm Control
321