Users Guide

Dell#01:02:12: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1 down - card
removed
Related Commands
reload— reboots the system.
show system stack-ports
Display information about the stacking ports on all switches in the M I/O Aggregator switch stack..
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the command output without
the Connection eld.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface
and Connection elds.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show interfaces command shown in the following example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone.
Interface The unit/port ID of the connected stack port on this unit.
Link Speed Link Speed of the stack port (10 or 40) in Gb/s.
Admin Status The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected.
Example
Dell# show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/33 40 up down
0/37 1/37 40 up up
1/33 40 up down
1/37 0/37 40 up up
Dell#
Example (Status)
Dell# show system stack-ports status
Topology: Daisy chain
Interface Link Speed Admin Link Trunk
Stacking Commands
313