Users Guide
23
Stacking Commands
Stacking is supported on an Aggregator only on the 40GbE ports on the base module. Stacking is limited to two Aggregators in the
same chassis in a single stack. Up to three stacks are supported in an M1000e chassis.
Stacking provides a single point of management and NIC teaming for high availability and higher throughput. To congure an
Aggregator stack, you must use the CLI.
The stacking commands are always available and operational, whether or not an Aggregator has a stacking module inserted. You can
use the commands to pre-congure an Aggregator, so that the conguration settings are invoked when the Aggregator is attached
to other Aggregator blades.
For more information about using the Aggregator stacking feature, refer to the Stacking Aggregators chapter in the Dell Networking
OS Conguration Guide for the M I/O Aggregator.
You can use the following commands to manage a stack of Aggregator I/O modules:
• power-cycle stack-unit
• reset stack-unit
• show system stack-ports
• show system stack-unit iom-mode
• show system stack-unit stack-group
• stack-unit iom-mode
power-cycle stack-unit
To hard reset any stack unit including master unit.
Syntax
power-cycle stack-unit unit-number
Parameter
Unit number The unit number ranges from 0 to 5.
Defaults None
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Stacking Commands
311