Users Guide
21
Quality of Service (QoS)
The Dell Networking operating software commands for quality of service (QoS) include trac conditioning and congestion control.
QoS commands are not universally supported on all Dell Networking Products.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to dene the QoS conguration on a per-physical-port basis.
Policy-Based QoS Commands
Policy-based trac classication is handled with class maps. These maps classify unicast trac into one of four classes. The system
allows you to match multiple class maps and specify multiple match criteria. Policy-based QoS is not supported on logical interfaces,
such as port-channels, VLANs, or Loopbacks.
bandwidth-percentage
Assign a percentage of weight to the class/queue.
Syntax
bandwidth-percentage percentage
To remove the bandwidth percentage, use the no bandwidth-percentage command.
Parameters
percentage Enter the percentage assignment of weight to the class/queue. The range is from 1
to 100% (granularity 1%).
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-out)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The unit of bandwidth percentage is 1%. A bandwidth percentage of 0 is allowed and disables the scheduling
of that class. If the sum of the bandwidth percentages given to all eight classes exceeds 100%, the
bandwidth percentage automatically scales down to 100%.
Quality of Service (QoS)
273