Users Guide

LACP LAG 1 is an aggregatable link
A-Active LACP, B-Passive LACP, C-Short Timeout, D-Long Timeout
E-Aggregatable Link, F-Individual Link, G-IN_SYNC, H-OUT_OF_SYNC
I-Collection enabled, J-Collection disabled, K-Distribution enabled L-
Distribution disabled,
M-Partner Defaulted, N-Partner Non-defaulted, O-Receiver is in expired
state,
P-Receiver is not in expired state
Port Te 0/1 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 128
Oper: State ACEGIKNP Key 1 Priority 128
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State BCEGIKNP Key 1 Priority 128
Dell#
Example (Sys-id)
Dell#show lacp 1 sys-id
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Dell#
Example (Counter)
Dell#show lacp 1 counters
----------------------------------------------------
LACP PDU Marker PDU Unknown Illegal
Port Xmit Recv Xmit Recv Pkts Rx Pkts Rx
-----------------------------------------------------
TenGig 0/1 200 200 0 0 0 0
Dell#
Related Commands
clear lacp counters — Clears the LACP counters.
show interfaces port-channel — Displays the information on congured Port Channel groups.
show link-bundle-distribution port-channel
Display the trac-handling and utilization of the member interfaces of the port channel.
Syntax
show link-bundle-distribution port-channel
Command Modes EXEC
EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.3.0.0 Introduced on the M I/O Aggregator
Usage Information The following table describes the output elds of this show command:
Link Aggregation Control Protocol (LACP)
251