Users Guide

Defaults 32768
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
port-channel mode
Congure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are dened in Usage Information .
passive Enter the keyword passive to set the mode to the passive state.
NOTE: LACP modes are dened in Usage Information .
o Enter the keyword off to set the mode to the o state.
NOTE: LACP modes are dened in Usage Information .
Defaults o
Command Modes INTERFACE
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information LACP Modes
Mode Function
active An interface is in an active negotiating state in this mode. LACP runs on any link
congured in the active state and also automatically initiates negotiation with other
ports by initiating LACP packets.
passive An interface is not in an active negotiating state in this mode. LACP runs on any
link congured in the passive state. Ports in a passive state respond to negotiation
246
Link Aggregation Control Protocol (LACP)